Jog Conveyor Dryers
目的和操作原则
JOG输送机干燥机（JCD）主要用于涂布过程后，以防止在袋装期间将湿核从夹住。亚搏手机版网页登录由于机器内部合理产品的处理非常温和，涂层上没有磨损的危险。
Wet product (yellow), coming from the coating machine, is fed to the inlet bin of the JCD. The product passes the feed regulation slide and enters the drying section, where warm air (red) is blown through the product layer from underneath. Moist air is aspirated from the top (blue) and led to a de-dusting plant. The amount of aspirated air is app. 10% higher than the warm air amount, thus creating an under pressure inside the machine, preventing any exit of dust. The airflow through the product on the drying grid (= perforated sheet) creates a fluidized bed. By means of the frequency-controlled eccentric drive, the product is conveyed towards the finished product outlet (green). There is a possibility to install a screening section with two screen layers at the end of the machine, to screen out over- and undersized material (orange). This screening section is mainly used when running pelleted or encrusted seed, as well as weight gained kernels, mainly to remove clumps of kernels and grit.
机器系列
The Jog Conveyor Dryer JCD is available in 2 different widths, 625 and 1.250 mm. The number of drying-, cooling and screening sections is flexible but should not exceed the maximum amount of 8 sections (6 drying-/ cooling sections, 2 screening sections)
Warm Air Supply
热空气必须提供给球迷们智慧的干燥器h adequate pressure (~ 1.000 Pa). All conventional heat sources (Gas, Oil, Steam, Solid fuel) are suitable for the JCD operation. Depending on customer requirements and availability of heat sources, Cimbria Heid is able to engineer a tailor-made solution. Special attention should also be paid to expensive heat processing. The usage of energy-saving and recovery systems is also extremely important to our valued customers.
为了保护合理的种子的发芽能力，暖空气温度限于最大值。45°C。温度传感器在暖空气供应中保证符合可调温度限制。在超过该限制的情况下，综合过程控制单元将关闭或减少加热设备（取决于组合物）。亚搏手机版网页登录
热源示例
油炉生产热水或蒸汽
散热器的印第安纳州irect heating (heat source: hot water or steam)
线燃气燃烧器直接加热
Usage of existing warm air from other parts of the plant
特征
Feeding device
To assure constant feeding of the JCD, pre-bins and feeding devices are used (mainly electromagnetic feeders). For heavily flowing or bridging products (e.g. grass seed) we are also able to supply dosing belts.
偏心驱动
The shaking movement produced by the eccentric drive enables a gentle and uniform flow of seed through the dryer. The integrated dynamical counterbalancing system prevents vibration to the steel platform or building.
干燥网格
The drying zones are covered with perforated sheets, which are easily extricable from the side of the machine for cleaning purposes. Depending on granulate- sizes of the specific product to be dried, the screen perforations are evaluated individually to prevent plugging or for small particles from falling through.
Screening section
按需，JCD可在干燥/冷却区域后配备筛选部分。本节包括2个屏幕层，彼此以上排列为顶部和底部屏幕。这用于去除超大（丛粒粒）和下尺寸（砂砾，灰尘）颗粒。借助于良好的橡胶球箱的永久屏幕清洁系统可在此过程中自动堵塞。亚搏手机版网页登录
使用权
For cleaning or supervision purposes, the aspiration hoods on top of the drying sections can be opened easily, giving excellent access to the whole drying grid. A frequent change of product variety is, therefore, no problem.
Ease of use
All regulation slides, screen- clamping, and speed regulation of the drive are positioned outside the machine. Therefore, operators are not forced to get in contact with parts contaminated by the coating agent.
Our Jog Conveyor Dryers operate worldwide
大量全球专利证明了高研究和开发支出，并表明了我们植物和机器的高工艺标准。全世界都有布拉特尼公司的产品被购买并成功运营：我们的大约98％的产量出口竞彩亚博。作为布拉德尼公司的成员，可以通过提供对客户及其竞彩亚博植物的永久性支持的全球高度合格的合作伙伴网络。
Jog Conveyor Dryer Data Sheet
The jog conveyor has a modular construction and can be used for conveying, cleaning, and drying grain (for example, coated or dressed materials) and similar products.
The jog conveyor works by the action of the eccentric shaft which, via connecting rods, causes the conveyor to move backward and forwards, which results in the movement of the material via the coiled suspension units. The jog conveyor transports material solely and empties the material at the outlet/outlets.
In order to facilitate cleaning processes, the machine is constructed with a screen system.
它设计有加热部分和筛分部分。每个加热部分通过使用JCD下方的加热器和鼓风机分别用暖空气供应。每个筛分部分由2个屏幕组成，溢出的顶部屏幕，灰尘的底部屏幕，具有连接喷口DM120mm，用于抽吸。
The main drive is a 4 kW – squirrel cage motor (standard 3/PE 400V 50Hz). The operation of the drive must be by frequency inverter (not included with the JCD).
在甲板上的入口处的可调节馈电栅极确定JCD甲板上的层的厚度。
技术数据
Type JCD 1250 |
6 + 2 | 6 + 2 | 6 + 2 |
| Motor (standard) kW | 4. | 4. | 4. |
| 空气要求M³/ h | 4.2.000 | 35.000. | 21.000 |
| 尺寸mm 长度 Width Height |
7905 2060 1850 |
6305 2060 1850 |
3695 1840年 1850 |
| 净重/公斤 | 3300. | 2700 | 2100 |
| 动态加载在6 Hz n PH= PV = |
+/- 300 +/- 1200 |
+/- 250 +/- 1000 |
+/- 170. +/- 650. |
技术数据can vary for certain of the above due to too continued development or a different machine composition.
